Welcome, visitor! [ Register | LoginRSS Feed

Box1
 

 

3d Printer -Tronxy P802MA Anet A8

Thought I'd get a 3d printer.. looked around, finally got this one on Ebay, a RepRap Prusa i3 design. Cost $242 US, from China. http://www.ebay.com/itm/Upgr...

3137 total views, 1 today

before
 

 

Toyota Matrix / Pontiac Vibe seat adjustment

I recently bought a 2005 Pontiac Vibe, and the seat was killing my back after owning it for a few weeks. Doing some research on the internet, I discovered that ...

18282 total views, 1 today

skin wire
 

 

Raspberry- Pi On/Off switch

This is a simple on/off switch for a Raspberry Pi or Arduino. I wrecked an Arduino board by unplugging the power cord too many times, so I put a simple switch ...

795 total views, 1 today

Hooked up
 

 

Internet Quick Disconnect

There are many types of network switches available and they're only about $50.00. This is an "unmanaged network switch" which basically means that its the simpl...

698 total views, 1 today

Powered Up
 

 

Wireless Microphone Transmitter

Got this small wireless FM transmitter the other day to play around with. Range with good quality voice was around 50feet for my test unit but would probably be...

497 total views, 0 today

Remove cover1
 

 

Nissan NV200 Compustar Remote Start Install

This is step by step installation of a Compustar CM7000 Remote Start and Security installation. Surprisingly, I couldn't find information online for a Nissan NV...

793 total views, 1 today

Contact Positioning
 

 

Electric Motor

This is a motor demonstration project I made from a posting I seen on Thingiverse. https://www.thingiverse.com/thing:663034 As posted on Thingiverse, the ...

637 total views, 2 today

Steamer complete
 

 

Emergency Water Heater

My girlfriend was throwing out her Shark Steam Cleaner .. not working so I ripped it apart to see if I could get a useful hack project out of it. Anyway, it tur...

660 total views, 1 today

Assembly
 

 

NV200 Roof Rack

NV200 Roof Racks are quite expensive. Also I couldn't find a basic simple roof rack for my van and didn't want a heavy duty industrial type. No other choice tha...

244 total views, 1 today

switches
 

 

license plate hinge

This is a "license plate hinge" that we made once for a movie set out here. A control cable is attached to the license plate bracket and pulls it in and out. Th...

930 total views, 1 today

Page 2 of 4 1 2 3 4

Totally Free — Idea Exchange Forum for Makers, Hackers, Inventors, and D.I.Y. Repair Projects