Welcome, visitor! [ Register | LoginRSS Feed

About magna

  • Member Since: 2015-12-30

Description

Ads / Latest items listed
Powered Up
 

 

Wireless Microphone Transmitter

Got this small wireless FM transmitter the other day to play around with. Range with good quality voice was around 50feet for my test unit but would probably be...

28 total views, 0 today

Steamer complete
 

 

Emergency Water Heater

My girlfriend was throwing out her Shark Steam Cleaner .. not working so I ripped it apart to see if I could get a useful hack project out of it. Anyway, it tur...

236 total views, 1 today

Closeup
 

 

In Home Key Fob switch

This is a Sonoff remote control 110 volt switch from Sonoff. These are available on Ebay for about 10.oo US: http://www.ebay.ca/itm/Sonoff-433Mhz-RF-WiFi-Wir...

231 total views, 1 today

Hooked up
 

 

Internet Quick Disconnect

There are many types of network switches available and they're only about $50.00. This is an "unmanaged network switch" which basically means that its the simpl...

301 total views, 0 today

Complete
 

 

Raspberry Pi Laptop

This is a laptop I made with a Raspberry Pi-3, and a plastic case from an old Arduino kit. I used two 6-volt batteries in series for a 12 volt power source, (be...

893 total views, 1 today

Vaio plug
 

 

Computer power plug

When I was servicing computers, the most common problem was a broken power plug. Here is a tip on how to fix a broken power plug in a Computer. First disassembl...

607 total views, 1 today

start
 

 

2005 Pontiac Vibe Door Buzzer removal

The door/key/seatbelt buzzer was driving me crazy.... it had to go. Here is how to I ripped it out. (Don't throw it away, you can always put it back in for when...

684 total views, 1 today

Alternator removed
 

 

Alternator rebuild

An alternator is a fairly simple car item to repair. I've repaired about 50 of them and 99% of the time the fault is always worn brushes. You can buy new brushe...

361 total views, 0 today

skin wire
 

 

Raspberry- Pi On/Off switch

This is a simple on/off switch for a Raspberry Pi or Arduino. I wrecked an Arduino board by unplugging the power cord too many times, so I put a simple switch ...

375 total views, 0 today

DCP_0741
 

 

Valkyrie Motorcycle seat build

The stock seat was too high and uncomfortable on my 1998 Valkyrie and no aftermarket ones are available. The bike is quite heavy and I had to make something tha...

1133 total views, 0 today